You are here: Home › Re: [neira] Balsa Fish Project

Re: [neira] Balsa Fish Project

swied User offline. Last seen 28 min 22 sec ago.
Location: San Diego, CA, USA
Joined: Nov 21 2006
Posts: 705
Points: 385

Re: [neira] Balsa Fish Project

Posted: November 22, 2006 - 9:34am | #1 | Back to Top

Thanks offering to create a CAD file for the rocker template. I took a side-on photo of the board that I am copying (see attachment below). I didn't make it to the beach yet, so I would definitely appreciate your help.

I checked and my wood is tall enough to fit the rocker of the board. My shortest board is 4 3/4'' tall. I put the board flat on a table, and the highest point was 4 1/2''. The length of the board is 6' 4''.

Hopefully the picture size isn't too small. The maximum file size that I could post is 35 kb. I'm not too worried about getting an exact match. I just need an outline that looks like it will be right for the board, and will ride well.

copy_board_rocker.gif
Balsa Fish Project By: swied (145 replies) November 22, 2006 - 12:12am